IBALDEV-4678

Hub: Load plan page - Add Move to load button on the map

Added the Move to load button on the map on the Load plan page. it is possible to select stops on the map. By holding Ctrl and clicking the stops, you can select them one-by-one. By holding Shift and clicking, you can create a box that can highlight multiple stops at once. You can move selected stops to other loads by pressing the Move to Load button in the top left of the map to optimize your route plans, minimize travel time, and maximize resource utilization.

IBALDEV-4425

Hub: Consignment - Possibility to go inside of load details

Added the possibility to go inside of a load details from the Consignment details page. By hovering over the load key and clicking on it, a load will be opened in a new tab of the browser.

IBALDEV-4444

Hub: Map view - Route toggle on map

Added the Route toggle on the map on the Map view page. If you enable the Route selector on the map, you will see a suggested route on the road network. 

IBALDEV-4623

Hub: Do not allow moving consignments to load when depot doesn't match

Added the restriction to move consignments between loads when a consignment depot doesn't match a load depot. 

IBALDEV-4679

Hub: Map view/Load plan pages - Add info icon with commands to select stops on the map

Added the Info icon with commands on the map that can be used for selecting stops. 

IBALDEV-4688

IBALDEV-4689

Hub: Environment settings -> Devices - Add Minimum photos field

Mobile app: Consider Max and Min photos settings for POD and Vehicle check

In environment settings, in addition to the maximum number of photos, added the possibility to define the minimum number of photos for POD's and vehicle checks. With the default value of zero for the minimum, photos are optional, but when the value is greater, the driver will be required to record photos. You can also remove the possibility of adding photos for a POD or a vehicle check by setting both the minimum and maximum to zero.

IBALDEV-3994

Mobile app: Package level failures for consignment POD with pre-defined packages

When creating a POD for a consignment with pre-defined packages, you will now be able to select which packages have been delivered. For undelivered packages, a prompt will allow you to specify a failure reason code. The status of a POD will be automatically changed to "Partially successful" if there is at least one undelivered package. The total count of delivered packages versus the planned count will be shown above the list of packages. Later, this possibility will be also available for a consignment with no pre-defined packages, for example ad-hoc POD's. In a future release, package-level failures will be shown when viewing a POD both in the mobile app and the Hub.